Balance the amplifiers when ALC is set at 100%

  1. Put the amplifiers in standby mode
  2. Reduce the output level of the exciter to the minimum by keeping pressed the "-" button in the front panel (second page)
  3. Disable the ALC on the amplifiers (via the web GUI or the front panel menu)
  4. When the exciter is at minimum level, turn on the amplifiers
  5. Raise the output level of the exciter via the "+" button in the front panel until you reach about 50mW
  6. Verify that the output power levels of the amplifiers are similar
  7. Put a power set point at the desired power (via the web GUI or the front panel menu)
  8. Wait 15 minutes and verify if the output power levels of the amplifiers are still similar